The unit now reports position every second or two. NMEA data is output at baud, 8, N, 1,. If you are connecting to a standard Serial port pictured left then it is most likely Com Port 1 or 2 and may be labeled on the PC. You may have to modprobe cdc-acm. This setting allows the software to reduce the number of points to something the GPS can handle. Nmea Data Messages Magellan gps tracker user manual. The driver will create a COM port for you, but will not tell you where it is.

Uploader: Shabar
Date Added: 13 May 2004
File Size: 10.66 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 86828
Price: Free* [*Free Regsitration Required]

To get to the Communication Menu press the Menu buttonselect the Adv. Don’t have an account? The supplied driver may not work with Mageplan but a Vista driver is available on the Magellan web site.

NMEA data is transmitted through the serial port. NMEA data is output at baud, 8, N, 1. To print the manual completely, please, download it. Communication with a Magellan is bi-directional, and you can use the software to program waypoints and routes into the GPS, and retrieve a track log from the GPS, as well as explirist your current position. There are several NMEA output message sets, each with a slightly different appli.


The Explorist is seen as a disk drive by the PC. For the Explorist and OziExplorer to communicate the correct communication mode must be specified in the Exploristthis is done by using the Communications Menu. How does that work on popular OSes? The baud rate can also be set toexplorits You should see the device listed there once your driver is installed It will be “COM” followed by a number.

For almost all programs, explotist “V2. It is this com port which must be used in OziExplorer configuration as the Com Port number. If your GPS manual does not specify these limits, it might take some experimentation to get them right. Table of Contents Add to my manuals Add.

If you experience problems importing tracks or sometimes exporting ,agellantry this: Autopilot cross track error, direction to steer, status of GPS, route status.

Magellan GPS Tracker User Manual: Nmea Data Messages

A Serial Port is also known as a Com Port and both names are used throughout this document. By pressing ‘print’ button you will print only current page. Nnmea Data Messages Magellan gps tracker user manual.

Double click on Modems, this opens the modem properties, select the Advanced tab, click on Advanced Port Settings button, the Com Port Number is at the bottom.


Here are a couple of methods to determine. Page of Go. Mageplan on the computer must recognize the device and present it as a virtual serial port to the application.

Connecting a Magellan GPS

When you send a route to the GPS, if the number of waypoints exceeds this limit, it is sent as a number of separate routes, each containing the maximum number of waypoints. Time, latitude, longitude, speed, heading, and date. It usually just works.

I have software that wants “NMEA”. It is typically used to display a current position on eexplorist map. Then select Baud and choose When you send a track to the GPS, it may get truncated if there are too many trackpoints. However, you can use the commands in the GPS menu to transfer data, while indoors.

FAQ: What NMEA messages does ArcPad support?

To set up the interface, first setup the GPS interface mode. These settings are acceptable to most equipment and software ap.

Magellan thales navigation gps receiver user manual gps74 pages.