EXABYTE 110L DRIVER

Make sure you do not assign duplicate IDs within a bus. The range is 0 the most recent event through Press the down arrow key to display the Next Cartridge screen. For the device at the physical end of a bus, install a terminator on one of the SCSI connectors for that device. Run the library in demo mode — Set options for running the autoloader in a continuous demo mode, where the robot randomly moves cartridges between slots. Click on Tape Drive Statistics.

Uploader: Kazibei
Date Added: 2 August 2005
File Size: 34.92 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 63161
Price: Free* [*Free Regsitration Required]

Specify the destination element for the robot. Table Using the Restart option to control processing after an interruption 50 If Restart is Make sure you do not assign duplicate IDs within a bus.

Exabyte 110L Plus – tape autoloader – LTO Ultrium – SCSI Series

Run individual tape drive commands — Issue commands to clean the tape drive and unload a cartridge from the tape drive. In the Properties screen, make sure the fields contain the following values, then click OK. Figure Remote management utility — Serial Interface Configuration page 4. For optimal performance and convenience, two autoloaders can be mounted side by side in a standard 19″ rack.

Installed a cleaning cartridge in the appropriate slot. Reach Position The robot fingers are closed 1 or open 2.

  AIRLINK DWL-G510 DRIVER

The Esabyte option instructs the autoloader to clean the tape drive automatically when necessary and without disrupting normal operation. The new setting appears on the screen. The factory default user name exabhte anonymous and the password is Exabyte.

If a cartridge is in the tape drive, the robot waits for the cartridge to be ejected, then returns it to its original slot. Storage by Rick Broida Sep 17, If the autoloader and tape drive will share one bus, use a jumper cable to connect them, as shown in Figure Reset the autoloader only to clear certain error conditions, and power off the autoloader only to perform maintenance or to store it.

Exabyte L Ultrium Tape Drive |

Click on Set the robot control mode. Operation When you are ready to put the autoloader into operation: Data Transfer Rate compressed. Click on the Start Demo button. Select the Transfer menu.

Figure Remote management utility — Bar Code Rxabyte Statistics page Table describes the information on this page. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. Click the radio button for the new baud rate. Check or uncheck the Verify barcode checksums box. To use this slot for a cleaning cartridge, you must set the Clean Slot option during autoloader configuration described on page The best deals from Amazon’s one-day storage sale Amazon slashed prices on some 20 items.

  GATEWAY GT5028 NETWORK DRIVER

Retrospect: Storage Devices > Exabyte L Autoloader

For the bus attached to the autoloader, add 5 centimeters 2 inches for the internal cable length used by the autoloader. When cleaning is required, the autoloader displays a cleaning message on the Status screen. Setting Up Remote Manager Security If you want to restrict access ecabyte the remote manager utility, you can set up a password that users must enter in the utility before changing configuration options.

A prompt similar to the one below appears. Top performance for a low price Top performance for a low price by Dong Ngo. To display additional Statistics screens, press the down arrow.

If the element is not reserved, this field is 0. The IP address is used to route information from the autoloader to the server. Figure Console Help screen Note: